TM - ITW CP

PRODUCTS

TM

1/1

TM

Midi Shoe

The TM hanger is used to support trusses in lower load applications from bottom chord depths 97mm and above.

Suitable for use with trusses (97mm ≤ bottom chord depths)
New and improved design achieves higher load carrying capacities
Tested and approved for H&H thin joint system–rapid building techniques, designed for speed of install and airtightness

Z275

Galvanised Mild Steel

Up to 9.54kN

Solid Timber Header (min. C16)

Technical Portal

Customer Services

CULLEN TECHNICAL GUIDE

Materials & Resources

New and improved design achieves higher load carryin capacities

Additional side fixings allow for increased uplif capacity

Rear location tab to assist with installation

Economical solution for low load applications

Paslode 3.4 x 35mm Electrogalvanised Square Twist Nail

Cullen products have been tested and CE marked to the requirements of ETAG015 using 3.4 x 35mm square twist nails.

Refer to the Cullen Technical Guide.

Additional side fixing holes for increased uplift performance.

Rear location tab to assist with installation.

Related Products

View All Products

KM

TS

Paslode Square Twist Nail

Paslode Square Twist Nail

KH

KHL

HMH

Support you can rely on

Expert technical guidance and customer service, from design to site.

Customer Services