Floors
Roofs
Walls
Fixings
PRODUCTS
RA Range
RA Range
Restraint Angle Range
The RA hanger range comprises of 3 hangers to suit all applications: the RA, HRAD and RADS. This is a timber to masonry hanger range designed for use with I–Joists, Open Web Joists, LVL & Glulam. The hangers provide lateral restraint and require no masonry above to perform to their full capacity.
Z600
Galvanised Mild Steel
Up to 34.18kN
Application Dependant
Provides lateral restraint equivalent to restraint straps at 2m centres. Additional straps required for buildings over 2 storeys or openings greater than 600mm
No coursing option required as RA range supports joists on top of previous block course, allowing joist to be built in at one end without adjustment
Supporting block work only needs to cure for 3 days instead of the standard 28 days for traditional masonry hangers, speeding up the build process
Paslode 3.4 x 35mm Electrogalvanised Square Twist Nail
Cullen products have been tested and CE marked to the requirements of ETAG015 using 3.4 x 35mm square twist nails.
I-Joist
Open Web Joist
LVL/GL
Guidance
Ensure return flange abuts masonry
DO NOT apply any load to joist prior to RA being fully nailed
Fixings required into incoming member only. No fixings required into masonry
Do not use the RA range with trussed rafters.
Do not install the RA range onto a timber wall plate.
Support you can rely on
Expert technical guidance and customer service, from design to site.